The beautiful seams of ceramic tiles is a question that everyone will ask when decorating a house. So, our topic today is to learn about the key points and construction techniques for beautiful seams! Let’s find out together.
1. What should be paid attention to when constructing beautiful seams
1. When using a glue gun to apply caulking agent into the gaps, do not apply it for too long at a time. Seam sealant is a quick-drying product. For novices, just apply 20-30 cm at a time.
2. There must be no accumulation of water in the gaps before construction. Do not leave standing water on the ground, such as in the kitchen and bathroom, and be sure to drain the water before making seams. If there is water on the ground, the caulking agent will not solidify easily. At the same time, pay attention to indoor ventilation after caulking construction.
3. Each side of the sponge can only be used once. After applying the caulking agent with a glue gun, smooth it with a special scraper, and then wipe the overflowing caulking agent with a sponge. The sponge has four flat surfaces that can be used to wipe away the spilled caulking agent. You can only use each flat surface once, but it can be reused as long as the surface is cleaned in time.
4. Avoid eye contact and long-term skin contact with incompletely cured materials, and keep out of the reach of children.
5. The two-component caulking agent uses a mixing mode of internal and external hoses. If there is no construction for more than 30 minutes, the caulking agent in the hose will solidify. Pay attention to the time limit during construction.
6. When constructing small bricks with many cross joints, the principle of making vertical joints first and then horizontal joints should be followed. When encountering intersections, skip the light scraping when the joint sealant applied later reaches this point. , so that the seaming agent will less flow into the intersecting seams.
7. Make sure that the construction base material must be smooth, strong and dust-free. Never use poor quality white cement or caulking agent to lay the base, especially for narrow joints.
8. Before using the caulking agent, you should first vacuum up the dust in the gaps between the tiles with a vacuum cleaner and wipe clean both sides of the tile joints with towels to remove dust, oil stains and other contaminants. At the same time, use a cleaning shovel to remove contaminants on the surface of the tiles. .
2. Construction techniques for beautiful seams
1. Construction method
Put the caulking agent into the glue gun, and then slowly and evenly push the material into the seam. After making a line (about 0.2 meters), first block the material nozzle with a wooden wedge, and then use a small scraper or Use your fingers to immediately scrape off the caulking agent. The overflowing material on both sides of the brick joints can be wiped off with a moist sponge. Be sure to wipe it off before the caulking agent solidifies.
The sponge should be rinsed with water after each wipe so that it can be used again. If the seam width is more than 3mm and the caulking agent filled into the ceramic tile seams is relatively uniform, there is no need to scrape the caulking agent and let it level automatically.
2. Leave a gap of 1 mm deep
Before applying the caulking agent, use a rag or fine brush to clean away dust and other materials in the seams. Attach textured paper to both sides of the seam. The masking paper should be about 0.5mm away from the edge of the gap. Put the caulking agent on the glue gun and drive it evenly along the brick joints.
The construction is about 1 meter, and immediately apply it evenly with your fingers or a small scraper; when the sealant has not solidified (the construction is about 1 meter), peel off the masking paper smoothly.
The above content is the content of the article What are the key points and construction techniques for beautiful seam construction that the editor will share with you today! Hope it helps you! Slip, slip, slip!
